UC知道小断翻译，电学专业帮忙，1天内就结题
来源：百度知道 编辑：UC知道 时间：2024/06/27 16:08:31
This suggests that matching to better than 0.1% is required
which is probably best accomplished with prepackaged resistor
networks with excellent ratio match. The circuit of Figure
8 actually required a slight amount of mismatch in the two
(RF) resistors to compensate for mismatches elsewhere,
suggesting that the inclusion of a trimpot may be necessary
to obtain maximum performance.
STABILITY WITH THE GROUNDED LOAD CIRCUIT
The grounded load circuit is remarkably forgiving from a
stability standpoint. Generally, no additional measures need
to be taken to insure stability.
Any stability problems that do arise are likely to be a result
of the output impedance of the circuit appearing capacitive.
The equivalent capacitance can be expressed as follows:
Where: fo = THE GAIN-BANDWIDTH PRODUCT OF
THE AMPLIFIER
This capacitance can resonate with inductive loads, resulting
most often in ringing problems with rap
which is probably best accomplished with prepackaged resistor
networks with excellent ratio match. The circuit of Figure
8 actually required a slight amount of mismatch in the two
(RF) resistors to compensate for mismatches elsewhere,
suggesting that the inclusion of a trimpot may be necessary
to obtain maximum performance.
STABILITY WITH THE GROUNDED LOAD CIRCUIT
The grounded load circuit is remarkably forgiving from a
stability standpoint. Generally, no additional measures need
to be taken to insure stability.
Any stability problems that do arise are likely to be a result
of the output impedance of the circuit appearing capacitive.
The equivalent capacitance can be expressed as follows:
Where: fo = THE GAIN-BANDWIDTH PRODUCT OF
THE AMPLIFIER
This capacitance can resonate with inductive loads, resulting
most often in ringing problems with rap
这建议对好于 0.1% 相配被需要
哪一个或许最好完成的与预先包装的电阻
用优良的比比赛的网络。 身材的线路
8 实际上需要了微小量的错误结合在那二
(射频) 电阻为错误的结合其他地方偿还,
建议 trimpot 的包含可能是必需的
获得最大的表现。
安定用被迫停飞负荷线路
被迫停飞负荷线路显着宽大从一
安定立场。 通常, 没有另外的措施需要
被拿保险安定。
确实出现的任何的安定问题可能是一个结果
出现电容的线路的输出阻抗。
相等的容量能被表示成追从:
哪里: fo= 增益-带宽产品
喇叭筒
这一个容量能以归纳的负荷共呜, 产生的
最时常在充满的问题迅速的转变。
唯一的有效酬劳是简单的 " Q-痛叱者 "
技术: 决定共呜频率那归纳的
线路的负荷和输出容量。 然后，选择一
电阻价值十分之一个授职者的电抗在那
共呜的频率。 用一个电抗增加一个系列电容器
在那共呜的频率对电阻中的十分之一等于
价值。 一个交互的方法会将放一个小的授职者
而且以 RS 在系列中湿气电阻。