UC知道进入系统时出现蓝屏
来源：百度知道 编辑：UC知道 时间：2024/07/02 18:40:29
本来的主机是没硬盘的,硬盘是在另外一台电脑拆装过来的[能用的],驱动都安装好了[安全模式能进],但是启动的时候进到画面XP的时候就蓝屏了
蓝屏时出现 A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you ve seen this stop error screen,restart your computer.If this screen appears again,follow these steps;
Check to be sure you have adequate disk space. If a driver is identified in the stop message,disabie the driver or check with the mahufacturer for driver updates, try changing video adapters.
Check with your hardware vendor for any BIOS updates. Disable BIOS memory oprions such as caching or shadowing.If you need to use safe mode to remove or disable componerits,restart your computer,press F8 to select Advanced staetup options,and then select safe mode.
Technical information;
☆☆☆Stop;0x0000007E (0xC0000005,0xF7617756,0xF78BA42C,0xF78BA128)
蓝屏时出现 A problem has been detected and windows has been shut down to prevent damage to your computer.
If this is the first time you ve seen this stop error screen,restart your computer.If this screen appears again,follow these steps;
Check to be sure you have adequate disk space. If a driver is identified in the stop message,disabie the driver or check with the mahufacturer for driver updates, try changing video adapters.
Check with your hardware vendor for any BIOS updates. Disable BIOS memory oprions such as caching or shadowing.If you need to use safe mode to remove or disable componerits,restart your computer,press F8 to select Advanced staetup options,and then select safe mode.
Technical information;
☆☆☆Stop;0x0000007E (0xC0000005,0xF7617756,0xF78BA42C,0xF78BA128)
你现在所用的系统是不是原来计算机的系统，如果是请重新安装一下就可以！
---如果是在本机重新装的，那么在你装驱动之前是否可以正常进入，如果可以那么问题就是你所安的驱动不正确或是先装其它驱动，而后装主板驱动时多会出现这种现像！
最好是你能把蓝屏时的报错信息发过来看一下！！
最直接的解决办法，就是重装系统，然后装主板驱动，显卡，声卡等其它驱动当有要求重新启动时请重新启动计算机，如果这样你感觉麻凡就用雨林木风或深度技术的系统镜像安装盘。这几种办法都不能解决你只能看看硬件的问题！！
祝你成功
蓝屏一般是虚拟内存的问题 你看看是不是啊
找一套系统盘重装一下试试
我想是声卡驱动装错了。
在安全模式里去声卡试试能不能启动，如果可以了，得装声卡驱时，注意选择正确的驱动。
另外，装卡巴斯基有时也会这样，重启进入系统时，只需选择：按上一次配置启动计算机就可以了。
----------------------
1.如果是sata硬盘,请在bios里的sata里改为IDE或禁用SATA.
保存后重启试试.如果不行请看下一步.
2.估计是你原来的系统的主板与你现在电脑的主板不兼容.重装系统试一下.
如果装系统没问题...基本上就没问题了.
如果还不行..go on..
3.内存有问题,如果有两条,去一条;主板也有可能有问题了,去电脑大修吧.