双硬盘不能同时启动
来源:百度知道 编辑:UC知道 时间:2024/07/02 04:54:35
我电脑有两块硬盘以前好好的,现在两个硬盘不能同时装上,一同时装上,之后到WINDOWS进度条那里之后就蓝屏,独立运行那个都没事。
独立运行那一块硬盘都OK
两个一起用的时候BIOS中可以检测到 IDE0-IDE1,到进度条那个就蓝屏了
以下是蓝屏信息:
A problem has been detected and windows has been shut down to prevent damage
to your computer
if this is the first time you ve seen this stop error screen,
restart your computer. If this screen appears again, follow
these steps:
Check for viruses on your computer.emove any newly installed
hard drives or hard drive controllers. chece your hard drive
to make sure it is properly configured and terminated.
Run CHKDSK /F to check for hard drive corruption, and then
restart your computer.
Technical information:
*** STOP:0x0000007B (0xF8950528,0xC0000034,0x00000000,0x00000000)
我两块硬盘分别插在主板上的两个IDE口上了
独立运行那一块硬盘都OK
两个一起用的时候BIOS中可以检测到 IDE0-IDE1,到进度条那个就蓝屏了
以下是蓝屏信息:
A problem has been detected and windows has been shut down to prevent damage
to your computer
if this is the first time you ve seen this stop error screen,
restart your computer. If this screen appears again, follow
these steps:
Check for viruses on your computer.emove any newly installed
hard drives or hard drive controllers. chece your hard drive
to make sure it is properly configured and terminated.
Run CHKDSK /F to check for hard drive corruption, and then
restart your computer.
Technical information:
*** STOP:0x0000007B (0xF8950528,0xC0000034,0x00000000,0x00000000)
我两块硬盘分别插在主板上的两个IDE口上了
插在2个口子上,首先可以排除硬盘主从跳线问题。如果你的2个硬盘系统启动过程完全在独立的分区可以完成,根据你分别插在2个IDE口上看,是不可能发生你所说的情况的,再多的硬盘也没事。
现在根据你说的情况,唯一的可能是你启动过程所要装载的部分文件并不在一个分区里面,比如你原先单独启动时候,会有部分随启动运行的文件在原先的D盘,由于挂双硬盘产生分区交错,双硬盘本来去读D盘文件的变成读另一个硬盘的第一个分区,产生错误,导致启动失败。甚至你系统环境设置原先不在一个分区,因为分区交错造成目录、文件系统有异也可能造成启动失败。
看你写的代码一般是发生在换过主板后第一次进入系统时的.
但是你说你的硬盘单个都可以正常启动的话.那么,就可以说,不是你的硬盘问题.
这样吧,你插上两块硬盘后.再出现这个代码,你只要重新安装一下系统就可以了.
注意两块硬盘的主次..