求大家帮忙翻译一下 急 要求不是软件翻译的就好 待用中...
来源:百度知道 编辑:UC知道 时间:2024/06/30 13:29:18
论文中根据要求设计了5台电机主电路的设计图。切片机的运行控制技术要求输入信号30个,输出信号7个,且全部为开关量控制。欧姆龙型可编程控制器,CPM1A系列属于小型PLC。主机规格为40点I/O分配(24点输入,16点输出),因此需要增加I/O扩展模块。这种PLC采用多种编程设备进行编程,在现场调试和编程比较常用的是手持式编程器,它体积小,结构紧凑,便于携带。它具有逻辑运算、定时、计算、顺序控制、通信等功能。小型PLC价格十分便宜。
因此选用欧姆龙-CPM1A系列来实现切片机的控制,同时根据具体要求还设计了PLC的硬件电路图,以及梯形程序图的编制,并对梯形程序图进行软件仿真。
关键词:电动机;可编程序控制器;切片机
请大家帮帮忙啊 我都快愁死了 要等着用着
Slicer electric motor control system of the main drag there is 5, namely: ① band saw motor M1, drive rotary blade, cutting foam, by the AC contactor KM1 control; ② two Modaomen motor M2, M3, driven wheel of the abrasive blade to maintain a sharp blade, because of its smaller power, it can be an AC contactor KM2 control; ③ table motor M, for the DC motor to drive the table to move forward or backward; ④ turret motor M4, through the turbine / worm transmission speed, drive left and right screw is transferred or turned around, with the tool carrier to move up or down sleeve. Therefore the design of the use of PLC control, PLC's high universality, flexibility, and wiring is simple, functional expansion ability, and programming language is simple and easy to grasp, do not ask for much power.
Paper was designed in accordance with requirements of 5 of the motor main circuit design. Slicer control the operation of the technical requirements of the input signal 30, the output signa