头疼的译文 快来帮帮忙吆！急急急！！！！

来源：百度知道 编辑：UC知道 时间：2024/09/21 14:37:55
The controller source code was tested by copying the contents of the Timer 1 interrupt service routine into the main () method. It was then stepped through on the Spectrum Digital Development board using Code Composer’s debug feature. This demonstrated that the program was entering and exiting the controller blocks in the correct order and that the DMC library was working. Adding the ramp_voltage variable in the Open Loop V/HZ controller to the Watch Window showed the output voltage steadily increased until it reached its target value. To test this, a break point was defined after the V_HZ_PROFILE block and the debugger was set to run. Unfortunately the other two control algorithms couldn’t be tested in a similar way because they needed feedback from the motor for the variables to change. The Event Manger was shown to be working by connecting a CRO to the PWM outputs and varying the duty ratio in the source code. Finally a variable resistor was connected to the ADC channels and the mea

译文：“控制器原始代码由复制测试了定时器1 中断服务惯例的内容入主要() 方法。它通过然后跨步在光谱数字式发展委员会使用代码作曲家的调试特点。这显示出, 节目是输入和退出控制器块在正确次序并且, DMC 图书馆运作。增加ramp_voltage 可变物在开环V/HZ 控制器来手表窗口显示了产品电压平稳地被增加直到它到达了它的指标值。测试这, 转折点被定义在V_HZ_PROFILE 块以后并且调试器被设置了对奔跑。其它二种控制算法不能不幸地被测试用一个相似的方式因为他们需要反馈从马达使可变物改变。事件饲槽由联络CRO 到PWM 产品和变化显示运作义务比率在原始代码。一个易变的电阻器最后被连接了到ADC 渠道并且措施价值被观看了在手表窗口。从这些简单的测试它结束, 基本的软件结构和周边设定充分是工作为所有三种控制算法”快点感谢我吧！！！

我看了这位朋友翻的，我发现翻的不错，所以就不翻译了！你可以参考他的！