UC知道我是外行，看不懂，帮忙翻译一下，非常感激！！！！！
来源：百度知道 编辑：UC知道 时间：2024/09/28 13:48:48
All joints are grease-lubricated by means of a two line grease lubrication unit, consisting of:
- Grease reservoir
- AC-motor operated grease pump
- Grease commutation valve (line 1 / line 2)
- Electric control panel.
The grease pump station is a complete unit incl. its complete electrical control to adjust the greasing cycles. The grease pump station requires:
- One LV-feeder,
- Potential-free remote signals to/from the automation system to start/stop the lubrication cycle
- One potential-free general alarm signal to the automation system
- The end of line limit switch signal (S301).
The grease pump station lubricates all joints with a set lubrication cycle. After the shear is „ready for operation“ a lubrication timer starts in the pump station control, set to xx minutes. That timer integrates all operation times, even if the operation times may be shorter than the set lubrication cycle. This prevents an over-lubrication. When t
- Grease reservoir
- AC-motor operated grease pump
- Grease commutation valve (line 1 / line 2)
- Electric control panel.
The grease pump station is a complete unit incl. its complete electrical control to adjust the greasing cycles. The grease pump station requires:
- One LV-feeder,
- Potential-free remote signals to/from the automation system to start/stop the lubrication cycle
- One potential-free general alarm signal to the automation system
- The end of line limit switch signal (S301).
The grease pump station lubricates all joints with a set lubrication cycle. After the shear is „ready for operation“ a lubrication timer starts in the pump station control, set to xx minutes. That timer integrates all operation times, even if the operation times may be shorter than the set lubrication cycle. This prevents an over-lubrication. When t
所有连接不见都已经使用双线润滑油脂单元行了充分润滑。双线润滑油脂单元的组成部件包括：
润滑油缸
交流电机驱动润滑油崩
润滑油换向阀(1线 / 2线)
电器控制面板
你的问题是在是太专，太多。
翻译这种文章的价格起码要在100RMB/K字以上。
所以。估计不会有人翻了。