UC知道有个问题想请教一下.我每用protel99se设计好原理图后进行ERC检查,但每次都有错误,能告诉我为什么吗?
来源：百度知道 编辑：UC知道 时间：2024/06/27 12:22:29
我用尽了所有的积分
Error Report For : Documents\原理图.Sch 6-Jun-2007 21:32:55
End Report
还有在仿真时出现这种情况
R1 Error: Pin order data (PINS=1:[<pins>]) not in READ ONLY field 4. Pins sorted by pin-name.
R1 Error: Part type must be entered in READ ONLY field 1: type=<part type>(<spice prefix>)
R1 Error: Netlist data must be entered in READ ONLY field 5: netlist=<netlist data>
Setup Error: GND Spice Reference Net (specified in Analog Options) is not in the schematic.
Error Report For : Documents\原理图.Sch 6-Jun-2007 21:32:55
End Report
还有在仿真时出现这种情况
R1 Error: Pin order data (PINS=1:[<pins>]) not in READ ONLY field 4. Pins sorted by pin-name.
R1 Error: Part type must be entered in READ ONLY field 1: type=<part type>(<spice prefix>)
R1 Error: Netlist data must be entered in READ ONLY field 5: netlist=<netlist data>
Setup Error: GND Spice Reference Net (specified in Analog Options) is not in the schematic.
对~把你的错误提示发出来看看~也许能帮上忙呢
你中间的错误报告怎么没有东西呢就End Report ?
是不是软件的问题啊~卸载了重装
纺真的我没用过 不好意思
能发一下你的图么？？或者他有什么错误提示，让我看看